electrical safety test equipment, environment test equipment, test probes, go not go gauges

1.  Introduction IPX8 High Pressure Transparent Water Tank can meet the requirement of IEC60529 for IPX8 testing and IEC60598 . The pressure in the jar can be precisely automatically controlled in purpose of checking the tightness and the leak points (by observe the bubbling during the test ) .The equipment is mainly  consisted by transparent Sealed jar and control uni t .   2.   Features ●  For IPX8 test. ●   Working principle: The sample is placed into the water, close the lid  and setup the test pressure and pressure holding time, then start the equipment. When the sample is in water, increase the air pressure on the water surface to the set value and then maintain the pressure. If there is a leak in the sample, the water will be pressed into the sample, and the air in the sample will be discharged, and the leakage point of the sample can be observed through bubbles . After the test is completed, the pressure can be automatically stopped, and ...

Standard /Figure Number Description QTY DIN-VDE0620-1 Lehre1 (CEE7-C1) Gauge for pin hole size (5.0, 5.8, 6.0) Lehre für die groBe der steckerstift-Einfuhrungsoffnungen 3 DIN-VDE0620-1 Lehre2 (CEE7-C2) Gauge for checking the smallest opening width and smallest pull-off force of the contact sockets Lehre zur Prufung der kleinsten Offnungsweite und kleinsten Abzugskraft der Kontaktbuchsen 2 DIN-VDE0620-1 Lehre3 (CEE7-C3) Gauge for the insertability of two-pin plugs Lehre für die Einführbarkeit zweipoliger Stecker 1 DIN-VDE0620-1 Lehre4 (CEE7-C4) Gauge for the insertion of two-pole plugs with protective contacts on the side Lehre für die Einführbarkeit zweipoliger Stecker mit seitlichen Schutzkontakten 1 DIN-VDE0620-1 Lehre5 (CEE7-C7) Gauge to check the distance up to the first contact (5A, 5B, 5C, 5D) Lehre zur Prüfung des Abstandes bis zur erstmaligen Kontaktgabe 4 DIN-VDE0620-1 Lehre6A (CEE7-C9A) Gauge for the pin diameter Lehre für den stiftdurchmesser 2 DIN-VDE0620-1 Lehre6B (CEE7-C9...

IEC60884 Figure 20 Apparatus For Cord Retention Testing 1 Introduction Cord retention testing apparatus   is   designed   according to the IEC60884 -1   clause 23.2 figure 20. It is used to  check the effectiveness of the retention of the cable by the cord anchorage.  It’s applied to the removable plug, removable mobile socket, non-rewirable plug, rewirable mobile socket. the f lexible cable is subjected 100 time s to a pull of 50N/60N/80N/100N, and the pulls are applied practically without jerks 1 time/s. 2.  Specification Power Supply AC 220V±10% , 50 Hz/60 Hz Number of testing 1~9999( x1x10x100) Weight 10N*1, 60N*1, 20N*2   (Configured to test 40N, 50N, 60N, 80N, 100N weights) Material: SUS304 stainless steel Rate of testing 60 times/min Standard IEC60884   f igure 20, VDE0620 2. The according tensile force of the flexible cable: The rated current of the flexible cable(A) The rated voltage of the flexible cable(V) The tensile force 2....